5.4.3 Device Parameters Page
It is possible to view the product code and other
additional information in the Device Settings menu.
Fig. 19
5.4.4 Device Statistics page
From menu entry Device Statistics all of the statistics
are gathered during device operation are provided in
read-only mode.
Fig. 20
5.4.5 Network Configuration page
From menu entry Network Configuration it is possible
to change the setting of the device. It is possible
to decide whether the device requires an address
assigned statically, dynamically with DHCP or self-
generated. The device supports the Internet Protocol
(IP) in version 4 and 6.
From the same page it is possible to configure 2 DNS
and decide which mechanisms must be enabled
to automatically identify the devices in the local
network.
If the obtain DNS server address automatically is
disabled, it is still necessary to enter a value for the
primary and secondary DSN.
14
Fig. 21
It is possible to specify the time zone of the unit
installed.
NTP Server: It is also possible to specify if the device
needs to be synchronised with an external NTP
(Network Time Protocol) server.
• DISABLED: Select this option if you do not wish to
synchronise date and time of the device.
• STATIC: Select this option if you wish to
synchronise date and time of the device with
those of the NTP (Network Time Protocol) server
specified by the static address.
In order for the device to operate correctly,
it is necessary to synchronise it with the
VMS software using a NTP server.
The device is not fitted with a buffer battery
to maintain the date and time. If the device
is switched off, the values must be entered
again.
To control automatic recognition of the device on the
network, individually activate the following protocols:
UPNP, Zeroconf, WS Discovery.
You can enable the Quality Of Service (QOS) function.
In this case, you need to specify a value for the
DiffServ Code Points between 0 and 63.
MNVCMVXHDCAM_1813_EN