Table des Matières
Publicité
F. Attaching Top Cover Support Brackets, Top Cover Mounting Brackets, And Top Covers
.
See Section 4-3B for installation hard-
ware torque values.
1
Long Support Bracket
2
Side Support Bracket
3
Center Support Bracket
4
Button-Head Screw
Use 1/4 x 3/4 in. screws and nuts to attach
OM-261 093 Page 19
The 8 x 15 Ft model is shown.
2
3
4
5
side support brackets and center support
bracket to each long support bracket as
shown.
Use button-head 1/4 x 3/4 in. screws and
nuts to attach long and side support
brackets to perimeter ends. Use regular
head 1/4 x 3/4 in. screws and nuts to attach
1
long and side support brackets to extractor
sides.
5
Measure and cut proper length of foam
tape to fit across the top of the long, center,
and side support brackets. Peel off back-
ing from tape and apply tape to support
brackets.
Install long and side support
4
mounting brackets beneath
perimeter bracket, and also
beneath extractor.
301048007-5 / Ref. 300 963-2A
Foam Tape
Publicité
Table des Matières
