Table des Matières
Publicité
4-1. Selecting A Location
The 8 x 15 Ft model is shown.
!
Only qualified persons should in-
stall, operate, maintain, and repair
this unit.
!
Installation must meet all National,
State, and Local Codes − have only
qualified persons make this installa-
tion.
!
Do not move or operate unit where it
could tip.
!
Do not use this equipment to sup-
port personnel, large tools, or other
material.
!
Be sure the floor or other structural
support will support the weight of
the equipment.
4-2. Hardware List
Item No.
Part No.
1
010910
2
080389
3
108940
4
108941
5
120304
6
152461
7
167788
8
172684
9
194530
10
229678
11
601965
12
602159
SECTION 4 − ASSEMBLY
!
Do not use equipment to support
site-installed ducts, interconnecting
piping, or electrical services. All
ducts, piping, or electrical services
supplied by others must be ad-
equately supported.
!
Use only mounting hardware spe-
cifically designed for the structure
or material supporting the equip-
ment. Follow the recommendations
and installation guidelines provided
by the manufacturer of the mounting
hardware (if applicable).
Flat Washer, 3/8 in.
Hex Head Screw, 5/16-18 X 1 in.
Hex Head Screw, 1/4-20 X 3/4 in.
Hex Head Screw, 1/4-20 X 1 in.
Snap-in Clip For 17/64 in. Hole
Hex Nut, 1/4-20
Hex Nut, 3/8-16
Hex Nut, 5/16-18
Snap-in Clip For 11/32 in. Hole
Button Head Screw, 1/4-20 X 3/4 in.
Hex Head Screw, 3/8-16 X 1 in.
Hex Head Screw, 5/16-18 X 3/4 in.
Moving The Equipment
1
Lifting Eye
Use lifting eyes and hoist to move the as-
sembled unit. See Section 4-3I for addition-
al lifting information.
Clearance
Maintain adequate clearance from heat
sources and avoid interference with utilities.
Ductwork
Select a location that ensures straight inlet
and outlet ducts and minimizes directional
changes in ductwork.
Description
1
301 048007-1
OM-261 093 Page 14
Publicité
Table des Matières
