Mode 2 Charging; Starting The Charging Process - Mennekes Cable de charge en mode 2 avec IC-CPD pour la charge de vehicules electriques Mode D'emploi

5.3 Mode 2 Charging

WARNING!
Risk of loss of life if handled incorrectly!
The use of extension cables is not permitted. If an
extension cable is used, there is the risk that the cable will
burn as a result of thermal overload.
)
Always plug the charging cable directly into the wall
socket.
)
Check which maximum permissible sustained charging
current is specified for your wall socket.
In case of doubt, ask your electrical fitter. If you are
not sure, charge using a reduced charging current,
e.g. (8 A). Settings are modified using the "up/down"
buttons on the in-cable module.
)
Ensure that your vehicle is suitable for mode 2 charging
(refer to the operating manual of your electric vehicle).

5.4 Starting the Charging Process

)
Connect the plug (e.g. SCHUKO
installation socket. Insert the plug fully into the wall
socket.
The charging system will automatically perform the
following steps:
„ The wall socket is checked for miswiring (miswiring
detection).
„ It is also checked to determine if there is a connection to
a ground conductor.
If there is no ground conductor, the house symbol will
light up red. In this case, charging is not possible!
„ It checks that the prerequisites for correct charging have
been met. Note the LED indicators:
If a fault has occurred, the charging process is
interrupted. The fault is indicated by means of a red LED
that either flashes or remains on.
➡ "6.3 Status Display / Error Messages"
In this case, the charging cable must not be connected
to the vehicle!
NOTICE
Risk of malfunctions as a result of incorrect
installation of the wall socket!
An incorrectly wired wall socket will cause malfunctions
during the charging process.
)
Remove the plug from the wall socket.
)
Have the wall socket checked by a qualified electrician.
DE
EN
NL
, CEE) with the home
®
FR
IT
ES
CZ
27