Leica Digisystem i780231 Manuel De L'utilisateur page 39

Using the Transmitter
in Connection mode
Digisystem, How to Use the Transmitter
4
1. Plug the Transmitter's cable set into the connection socket.
2. Connect the black cable to the Earth Pin, ensuring that no services are below push the
Earth Pin into the ground.
3. Connect the red cable to the service.
4. Switch the Transmitter on, observe the Connection mode LED is illuminated and the
battery level is adequate. Change batteries when indicated.
5. Select the required power output level and frequency output. A good level of tracing
signal is indicated when the power output LED & audible tone changes from pulsed to
continuous.
6. Trace the signal using the Locator set to the same operating mode. Refer to "2 How to
Use the Locator" for more information.
5
1
3
6
2
38