How To Locate A Service Using The Transmitter - Leica Digisystem i780231 Manuel De L'utilisateur

3.3
Start up test
Digisystem, How to Use the Transmitter

How to Locate a Service Using the Transmitter

The following test sequence will take place every time the Transmitter is activated.
On test
Audio output
LEDs
Default mode selection
Test pattern
1
On throughout test sequence.
LEDs are all lit throughout the test sequence.
33 kHz and power output level two is automatically
selected. Induction mode is selected unless the Trans-
mitter's cable set or accessories are connected.
36