Leica Digisystem i780231 Manuel De L'utilisateur page 25

Digisystem, How to Use the Locator
Warning
Measuring Sonde depth
(550i & 650i only)
The depth reading might not reflect the real depth if your Locator picks up the signal induced
into the service by the Transmitter. This signal is radiated from the centre of the service.
This is even more important when the signal is produced by a Sonde, lying in a large diameter
conduit!
Precautions:
Always compensate depth reading for service size.
F
i
i
1. Switch on the sonde and set to
the required frequency. Refer
to "7 How to Use the Sonde"
for more information.
2. Select either 33 kHz or 8 kHz
mode to suit the Sonde's
output.
Position the Locator directly
over, and in line with the
Sonde. Refer to "7 How to Use
the Sonde" for more informa-
tion.
3. Press and hold down the
i Button for 2 seconds until the
dashed lines have scrolled
through once.
4. The display readout will indi-
cate the depth of the Sonde
and the Sonde mode icon will
be displayed.
24