Connection Between Rp-110 And Pc - Promax RP-110 Manuel D'utilisation

USER'S MANUAL. RP-110
5. EXPLANATORY PROVISION. Notwithstanding the accuracy of the software
granted, PROMAX ELECTRONICA, S.A. is fully exempt of liability for
consequences arising from any possible omission existing in the program or from
improper use by the end user of any of the information it contains and generates.
Nor can PROMAX ELECTRONICA, S.A. be held liable for the suitability or
accuracy of the data obtained for particular purposes or functions, since the only
obligation of the latter, under this Contract, is the provision of means and not of
results.
6. FINAL CLAUSE. The use of this software referred to herein signifies the tacit and
unconditional acceptance of its conditions.
7. JURISDICTION. Both parties, explicitly waiving any rights that may correspond to
them, agree to submit all controversies that may arise from this Contract to the
jurisdiction and competence of the Judges ad Courts of Barcelona.

5.4.1 Connection between RP-110 and PC.

The connection between RP-110 and PC is done via the data transmission cable
USB (mini — USB) supplied with the instrument.
Firstly turn off the instrument RP-110. Then connect the USB connector to a free
USB port of your PC. Finally connect the cable to the mini-USB port of the PROMAX
instrument.
07-2011
Figure 8.- Connection between RP-110 and PC.
Page 17