Control Software Rp-110; Description; Hardware And Software Requirements; Installation - Promax RP-110 Manuel D'utilisation

USER'S MANUAL. RP-110

5 CONTROL SOFTWARE RP-110

5.1

Description

This software is a program developed to allow the communication between a
computer and the RP-110.
It allows you to set up the test signals in a very easy and quick way, and sending
or receiving them from the instrument. It can also update the firmware of the instrument.
5.2

Hardware and software requirements

In order to be able to use the program correctly, the following requirements need
to be met:
•
Hardware requirements
Minimum configuration:
*
IBM-compatible computer, Pentium or higher.
*
10 Mbytes available on the hard disk (variable, depending on the files of
data available).
*
Pointing device or mouse (not essential, but highly recommended).
*
USB port available.
•
Software requirements
In order to be able to run the acquired software it is essential to have, Windows®
95/ 98/ ME/ 2000/ XP/Vista/7 operating system.
5.3

Installation

5.3.1 Installation of the software

VERY IMPORTANT REMARK
If a previous version of RP-110 Control has been installed, it will be necessary to
completely remove it before installing present version.
07-2011 Page 15