Backlight Mode; Lcd Contrast - Promax RP-110 Manuel D'utilisation

b) BEEP
This field allows you to activate (ON) or deactivate (OFF) the acustic indicator.
This indicator sounds when pressing any key.
c) BACKLIGHT MODE
This field allows configuring the ligthing on the screen. If YES, then the
backlight is always ON. If NO, then the backlight is always OFF. If AUTO, then
the backlight is activated if any key is pressed and after 5 seconds with no
activity the backlight turns OFF again.
d) UNITS
It allows you to select Level output unit between dBmV, dBµV y dBm.
e) LCD CONTRAST
It allows you to select the level of contrast of the display.
f) LOCK PILOTS
It allows you to enable or disable locking signal parameters. When is locked
(YES) you cannot edit the parameters. When it is locked it appears a padlock
icon .
g) PRESETS
This option allows you to set the parameters of the six pilot signals (See
Figure 4.-) and to save them grouped in one of the 8 memories of the
instrument. Once stored, the user can load a specific memory as needed.
Press UP or DOWN
the value of a parameter.
Press SEL
To activate a memory, first select on the field MEM the memory number, select
the ACTIVATE field and press SEL
Page 10
Figure 4.-
[4] to move between parameters or to change
[3] to enter, go next and exit an editable field.
USER'S MANUAL. RP-110
[3].
07-2011