Operating Instructions; Setup Mode; Scan Mode - Promax PROFI-70 Manuel D'utilisation

USER'S MANUAL. PROFI-70

4.2 Operating instructions

The PROFI-70 offers five operating modes:

1. SETUP MODE:

2. CONFIG. MODE:
3. SEARCH MODE: The operation mode SEARCH carries out an exploration of ISM

4. SCAN MODE:

5. ANALYSE MODE: Activating this operating mode allows users to make multiple
To access any of the several operation modes from the main menu (see fig 3)
press the programmable key [11], according to the lower selection box.
05/2008
The SETUP operation mode allows users to set the initial
configuration of the device, entering basic data into the system
such as the time, date, language, sound and autopower off.
Also, it reports on the battery charge condition, the firmware
version installed and the equipment's serial number.
The CONFIG operation mode allows users to set the basic
operating parameters for the analyser: Attenuation in
connecting cable, Selection between A or B input, and
setting the measurement time period on channel.
band in order to detect the transmitting stations and their main
parameters. The LOGGER function allows users to view and
print the different measurements made and store them for later
checks, transfers to PC or printouts. Up to 50 loggers can be
stored in memory, each with the measurements associated to
detected stations.
The SCAN operation mode shows the signal level of all
channels present in the ISM band. Additionally, it indicates the
numerical power level of a given channel through a floating
marker.
measurements over a channel according to the configuration
previously set in CONFIG mode.
Page 13