Maintenance And Cleaning; Uninstalling; Repair And Disposal - Kollmorgen AKD Série Guide De Sécurité

Masquer les pouces Voir aussi pour AKD Série:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 51

1.2.7 Maintenance and Cleaning

The drive does not require maintenance. Opening the drive voids the warranty.
The inside of the unit can only be cleaned by the manufacturer. To clean the drive exterior:
Casing: Clean with Isopropanol or similar cleaning solution.
Protective grill on fan: Clean with a dry brush.
Do not immerse or spray the drive.

1.2.8 Uninstalling

If a drive must be uninstalled (such as for replacement), remove the drive as follows:
1. Switch off the main switch of the switchgear cabinet and the fuses that supply the sys-
tem.
WARNING
Contacts can still have dangerous voltage present up to seven minutes
after switching off mains voltage. Risk of electrical shock! Wait at least
seven minutes after disconnecting the drive from the main supply power
before touching potentially live sections of the equipment (e.g. contacts)
or undoing any connections. Always measure the voltage in the DC bus
link and wait until the voltage is below 50 V before touching or handling
the drive.
2. Remove the connectors. Disconnect the potential earth connection last.
3. Check temperature.
CAUTION
During operation, the heat sink of the drive may reach temperatures
above 80 °C (176 °F). Risk of minor burns. Before touching the device,
check the temperature and wait until it has cooled below 40 °C (104 °F).
4. Uninstall. Remove the drive and power supply from the conductive, grounded mounting
plate in the cabinet.

1.2.9 Repair and Disposal

Only the manufacturer can repair the drive. Opening the device voids the warranty. Uninstall
the drive as described in (➜ # 11), then send the drive in the original packaging to the man-
ufacturer (see table below).
In accordance with the WEEE-2002/96/EC-Guidelines and similar, the manufacturer
accepts returns of old devices and accessories for professional disposal. Transport costs
are the responsibility of the sender.
Send the devices to the manufacturer addresses shown in the table below.
USA
Kollmorgen
201 West Rock Road
Radford, VA 24141
Europe
KOLLMORGEN Europe GmbH
Pempelfurtstr. 1
D-40880 Ratingen
Kollmorgen | kdn.kollmorgen.com | December 2015
AKD Safety Guide | 1   English
11

Publicité

Table des Matières
loading

Table des Matières