Transport; Packaging; Storage; Maintenance And Cleaning - Kollmorgen SERVOSTAR 300 Manuel D'instructions

S300 Safety Guide | 2 English

2.2.4 Transport

Transport the SERVOSTAR 300 in accordance with IEC 61800-2 as follows:
The servo amplifiers contain electrostatically sensitive components which can be damaged
by incorrect handling. Discharge yourself before touching the servo amplifier. Avoid contact
with highly insulating materials (artificial fabrics, plastic films etc.). Place the servo amplifier
on a conductive surface.

2.2.5 Packaging

The SERVOSTAR 300 packaging consists of recyclable cardboard with inserts.

2.2.6 Storage

Store the SERVOSTAR 300 in accordance with IEC 61800-2 as follows:

2.2.7 Maintenance and Cleaning

The servo amplifier does not require maintenance. Opening the servo amplifier voids the war-
ranty.
The inside of the unit can only be cleaned by the manufacturer. To clean the device exterior:
Do not immerse or spray the servo amplifier.
42 Kollmorgen | June 2015
Only by qualified personnel in the manufacturer's original recyclable packaging
Avoid shocks
Temperature: –25 to +70°C, max. 20K/hr rate of change,
class 2K3 acc. to EN61800-2, EN 60721-3-1
Humidity: max. 95% relative humidity, no condensation,
class 2K3 acc. to EN61800-2, EN 60721-3-1
If the packaging is damaged, check the unit for visible damage. In this case, inform the
shipper and the manufacturer.
Dimensions (HxWxD): 115x365x275mm
Labeling : nameplate outside at the box
Storage only in the manufacturer's original recyclable packaging
Max. stacking height 8 cartons
Storage temperature: -25 to +55°C, max. rate of change 20°C / hour
class 1K4 acc. to EN61800-2, EN 60721-3-1
Storage humidity: 5 ... 95% relative humidity, no condensation
class 1K3 acc. to EN61800-2, EN 60721-3-1
Storage duration: Less than 1 year without restriction.
More than 1 year: capacitors must be re-formed before setting up and operating the servo
amplifier. To do this, remove all electrical connections and apply single-phase 230V AC
for about 30 minutes to the terminals L1 / L2.
Casing: Clean with Isopropanol or similar cleaning solution.
Protective grill on fan: Clean with a dry brush.