Publicité
THANK YOU
for your purchase of the electric trainer IPANEMA II XPower!
We made a main effort while drawing and building this sailplane so that it is the best model you ever built and fly.
We provide you a kit with the highest quality and the best possible performances.
We wish you a great success while assembling and flying your new IPANEMA II XPower
It is, in our opinion, the ideal aircraft to take his first steps in RC aviation.
This aircraft is assembled without special gifts, from the moment you're careful and you follow the instructions illustrated step by step, telling you everything from A to Z.
Assembling is fast, count four or five evenings before being ready for first flight. The IPANEMA II XPower was designed around the suggested equipment, no surprises on that side
either; you plug and fly.
The power system of IPANEMA II XPower is as powerful as that of his IC fellow and allows flights of 20 minutes.
The flight is safe and easy as our other trainers COPACABANA and ACAPULCO.
The tricycle landing gear with steerable front wheel allows easy to perform taxis and take-offs and supports the worst landings!
Service this plane is easy and unique:
Charge the power battery (LiPo's can be charged in advance at the workshop - no memory effect)
●
Attach the wing to the fuselage with the four rubber bands
●
Switch on the transmitter
●
Insert the battery easily through the hatch at the top of the fuselage (no wings to remove)
●
Attach the battery pack on its tray with Velcro® tie
●
Connect the battery pack to the controller
●
Close the hatch with its magnetic lock
●
It's ready! You can fly!
●
IMPORTANT:
Please take a few moments to read this instruction manual before beginning assembly. Do an inventory of the parts using the parts list, to control that
there is no lack or imperfection.
Thank you to contact TOPMODEL immediately, if you note a missing part or a damaged part.
WARRANTY:
It is important to notify to TOPMODEL all damage or problems with this model within 7 days following the reception of the kit to be able to benefit the
warranty. In the event of return of the model, the customer is responsible for transport and return shipping cost is at his expenses. In the event of defect, the part will be
exchanged or replaced once this one will be delivered to TOPMODEL for expertise (transport on your cost). In the event of problem, do not hesitate to contact TOPMODEL.
TOPMODEL cannot control the dexterity of the modeler and cannot influence the builder during the assembly or the use of this radiocontrolled model, thus TOPMODEL will in
no way accept or assume responsability or liability for damages resulting from the use of this user assembled product.
The purchaser/user accepts all the responsibilities in the event of structural or mechanical problems.
TO ASSEMBLE THIS KIT
To assemble this kit, you'll need the items listed below:
■ ADHESIVE:
Cyanoacrylate thin and thick, epoxy 30' and 5' adhesives.
■ TOOLS:
Knife (X-acto), Allen keys, Phillips screw driver (small and medium), needle tip pliers, pliers, scissors, scotch tape, masking tape, double
sticking tape, mini drill (with bits), sanding paper, ruler, ball point pen, clips, alcohol, soldering iron, piece of cloth or rags, etc.
REMINDER
We take great care to delivering the best possible quality.
We kindly remind you that these models are not ready to fly and that the remaining work is an important part to get the model flying. For this, please,
check all glue joints and assemblies.
Safety first!
We thank you for your attention during the assembly of our kits, and wish you good and numerous flights!
TOPMODEL SAS
3
Publicité
