Wiring Installation - Superwinch LT2000 Guide Du Propriétaire

Table des Matières

Publicité

WIRING INSTALLATION

Step (1)
Connect the yellow and blue 6 ga. wires to the motor terminals. Route the
wiring back to the solenoid and connect to the yellow and blue contact posts.
Step (2)
Attach the short black and green leads to the solenoid terminals (Figure 6).
Install the short black jumper lead to the black battery negative post and to
the center terminal.
Step (3)
Attach the green and black leads from the toggle switch to the green and black
leads connected to the solenoid terminals.
Step (4)
Attach the red and black 6 ga. leads to the red and black contact posts on the
solenoid and connect the red wire to the unmarked end of the circuit breaker.
Connect the short red wire to the end of the circuit breaker marked "+"
Connect the other end of the short red wire to battery "+"
Connect the 6 ga. black wire to battery "–"
Figure 6
Yellow – 6 ga.
ATV MASTER WIRINGS
ATV main
switch
Green
Fuse
Red
Brown/Blue
Black
Red
ATV wiring
connection
optional remote
control
optional
1
WINCH
2
Blue – 6 ga.
Black
BATTERY
Black – 6 ga.
SOLENOID
"+"
to solenoid
Green
Red – 6 ga.
8
Step (5)
Check that all wiring is clear of sharp edges and pinch points.
Secure loose wiring with tie wraps or electrical tape.
WARNING
!
TEST DRIVE
1. Double check that all wiring is correct and that there are no exposed
terminals that can short to the vehicle frame.
2. Turn the ignition key to the ON position. Check winch for proper operation.
REMOTE SOCKET MOUNTING – optional
1. Determine the mounting location for the remote socket.
2. Drill three holes using the included dimensions as a guide.
3. Once the remote socket is mounted, route the jacketed green and black
leads back to where the solenoid is mounted. Splice the red lead to a key
controlled electrical wire on the ATV.
Figure 7 – Socket
Assembly mounts
from outside/in
CIRCUIT
BREAKER
to circuit breaker
WIRING INSTALLATION
Before testing winch operation, be sure to
reel off approximately two feet of wire rope.
1.77"
45mm
9
0 .26"
0 6.5mm
.89"
22.5mm

Publicité

Table des Matières
loading

Table des Matières