Dismantling And Disposal; Deactivation; Final Shutdown; Disposal - Rothenberger BS 450 Instructions D'utilisation

10

Dismantling and disposal

10.1

Deactivation

Danger!
Running saw band may cause serious severance injury!
Descending saw bow may pinch the operator!
Only an authorised person may deactivate the machine (see Chap. 2.5).
How to deactivate the BS 450:
 If a workpiece is still in the machine, remove it (see Chap. 7.5).
 Place the saw bow in the rear position.
 Turn the machine off at the main switch, and ensure it is not activated again.
 Pull the power plug-in out of the receptacle.
 If the machine is transported to a different location, set the saw bow to 45 degrees (see
Chap. 7.4).
 Secure the saw bow and the swivel-mounted control panel with transport anchors before
transport (e.g. appropriate cable straps).
10.2

Final shutdown

 Execute the steps from the previous section.
 Disconnect the power supply cable to the machine so that unauthorised persons cannot ac-
tivate the machine.
10.3

Disposal

Danger!
Climbing onto the machine poses a fall- and injury risk due to sharp machine
parts!
Workers may not climb onto the machine even when disposing of it. Use suitable
climbing aids (e.g. stepladders or multi-purpose ladders, but no leaning ladders).
Warning!
Crushing hazard for arms and legs during transport of machine!
• The in-company transport may only be conducted by authorised persons (see
Chap. 2.5) according to valid APR.
• Also ensure that no persons are in the transportation path or in the setup area
and wear safety shoes with toe-protection caps.
Attention!
According to EU regulations machine parts may not be discarded with unsorted
household garbage.
During disposal separate the individual types of materials and dispose of them in ac-
cordance with country-specific regulations.
Information
The BS 450 does not contain dangerous materials
The following rules must be observed when disposing of the machine at the end of its lifecycle:
• Adhere to the country-specific regulations regarding disposal of industrial machines
• If unsure, contact a professional disposal company
• Separate plastics from metal and dispose of these materials separately
• Dispose of seals and rubber parts as special waste
• Also dispose of electrical motors and electrical components such as controls, switches and
cables separately.
ENGLISH 63