Electrical Connection; Emissions - Rothenberger BS 450 Instructions D'utilisation

Attention!
The BS 450 may only be used to saw glass fibre-reinforced plastics when the GFP-
dust is ventilated with a ventilation system.
Dust is released into the air when sawing GFP, and this dust can very quickly shutdown
mechanical components and electrical equipment of the BS 450. Therefore, a suitable
ventilation system is absolutely necessary when sawing GFP.
3.6

Electrical connection

Operating voltage .................. 3N-PE-AC 400 V
Frequency ............................. 50/60 Hz
Power rating max. .................. 7,5 kVA
Connection type ..................... CEE-plug-in, 16 A, 400 V
Phase sequence .................... Field turning clockwise
Saw-band operation
• Mechanical output 1,25 kW
• With overload protection
• With electrical break
3.7

Emissions

Dust
Caution!
Sawing plastic materials releases fine dust into the air, which may harm the
operator's health.
• Adhere to the respective legal regulations and determined workplace threshold
values for dust.
• The proprietor is obligated to install a ventilation system and provide the operator
with a respiratory mask if workplace threshold values are exceeded!
EMC
The BS 450 complies with protection requirements in regard to interference immunity according
to EN 61000-6-2:2005 (Interference immunity for industrial areas).
The BS 450 complies with protection requirements in regard to interference emission according
to EN 61000-6-3:2007 (Interference emission for living-, commercial- and trade areas as well as
for small business).
Therefore, the machine may be operated in industrial- as well as in living- and commercial are-
as.
42 ENGLISH