Sawing - Rothenberger BS 450 Instructions D'utilisation

Information
With the pipe climping device it is possible to fasten pipes onto a max. diameter of 450
mm.
 Secure workpiece offcut that is not clamped in (e.g. with suitable lifting gear) so that these
pieces do not fall from the table after sawing.
 Place the saw band cover so that the saw band is only open in cross-sectional size of the
workpiece.
Remove workpiece from the machine:
 Stop the motors by releasing the push buttons.
 Press the emergency-off button so no one accidentally turns on the machine motor.
 Slide the saw bow in the rear position.
 Open the pipe climping device.
 Remove the workpiece and offcut from the machine with the help of a suitable lifting device
and possibly another person.
7.6

Sawing

Danger!
Running saw band may cause serious severance injury!
Descending saw bow may pinch the operator.
• The machine may only be operated by one person.
• Before sawing, the operator must ensure that the work area is clear.
Attention!
Falling, offcut workpieces may injure the operator.
• Secure workpiece offcuts that are not clamped in (e.g. with suitable lifting gear) so
that these pieces do not fall from the table after sawing.
• It is not permissible for the operator or the assisting person to hold or catch the
offcut piece
 Position the saw bow in the rear start position.
 If required, set the desired sawing angle (see Chap 7.4).
 Load the workpiece an fasten it (see Chap. 7.5)
 Turn on machine with main switch (see Chap. 7.3).
 Press push button at the handle of saw bow. The saw band starts.
Information
Press push button during the hole sawing process. If you want to interrupt the sawing
process, just release the push buttons.
• The motor of saw band stop.
 Pull saw bow forward slowly.
ENGLISH 51