Inserting The Saw Band - Rothenberger BS 450 Instructions D'utilisation

Warning!
Coiling up the old saw band poses an injury risk - especially for the facial
area!
Operator and assisting person must be especially careful and wear protective glass-
es.
 Coil up the old saw band to safely dispose of it.
 Remove all saw dust with a brush or vacuum cleaner from where the saw band used to run.
 The installation of a new saw band is explained in Chap. 9.4 .
9.4

Inserting the saw band

Danger!
Running saw band may cause serious severance injury!
Descending saw bow may pinch the operator!
The assisting person mentioned below may only enter the hazard- or working area
after deactivating the machine with the main switch.
Danger!
Climbing onto the machine poses a fall- and injury risk due to sharp machine
parts!
It is not permissible to climb onto the machine when performing maintenance- or any
other kind of work. Use suitable climbing aids (e.g. stepladders or multi-purpose
ladders, but no leaning ladders).
Attention!
After sawing the hot saw band may burn the operator!
The saw band poses an injury risk!
Always wear protective gloves when working on the saw band.
 If you have not already done so, execute the steps in Chap. 9.
 If the covers of the saw band have not already been opened, do so (see Chap. 9.3).
 Operator and assisting person are required to wear work gloves and safety glasses.
Warning!
Uncoiling the old saw band poses an injury risk - especially for the facial area!
Operator and assisting person must be especially careful and wear protective glass-
es.
 Carefully uncoil the band.
 Insert the saw band first around the diversion-wheel of saw band tensioning device (1), then
around the upper diversion wheel (2). Please make sure that the saw band rests centrally on
the gumming.
60 ENGLISH