Setup Screens - Miller Optima Manuel Du Propriétaire

3-5. Setup Screens

1
S e t u p
> 3 0 4
2
S e t u p
> O f f
3
S e t u p
> E n g l i s h
OM-2805 Page 14
P o w e r S o u r c e
M O D E L S
3 0 4
A c c e s s i b l e
M a n u a l M i g
L a n g u a g e
M O D E L S
P r o g r a m s
P u l s e r
To access Setup screens: turn
welding power source Off, press
and hold Select push button, turn
unit On, and hold push button down
until initial screen leaves.
To exit Setup screens, turn welding
power source Off and then On
again. Parameters that are dis-
played when the Setup screens are
exited are active.
1 Welding Power Source
Screen
.
Unit originally shipped with 304
models selected.
Select third line of display, and turn
knob until desired welding power
source type is displayed.
Choices are:
- 304 Models
- 350 Models
- 456 Models
2 Accessible Programs Screen
Select second line of display, and
turn knob until Accessible Pro-
grams is displayed. Select third line
of display and turn knob to access
each program and the CV MIG
mode and the Manual MIG Pulser
mode as desired. Select the fourth
line and turn knob to define each op-
tion On (accessible) or Off (not ac-
cessible).
Programs and modes that are de-
fined Off are not shown when the
operator scrolls through the dis-
plays in normal operation.
3 Language Screen
Select second line of display, and
turn knob until Language is dis-
played. Select third line of display
and turn knob until desired lan-
guage is shown. The choices are
English, French, Italian, and
Spanish.