Table des Matières
Publicité
SECTION 7 − TROUBLESHOOTING
7-1. Error Codes
1
M e m o r y
2
M e m o r y
7-2. Troubleshooting
Trouble
No weld output.
No control of weld output.
Erratic weld; incorrect weld
characteristics.
OM-2805 Page 36
E R R O R
P r o g r a m
C R C
W i l l
P r e s s
P a r m .
E R R O R
P r o g r a m
R a n g e
W i l l
P r e s s
P a r m .
Be sure welding power source Power switch is On.
Check welding gun and/or wire feeder if applicable.
Check welding power source control settings.
Tighten all interconnecting cord connections.
Check pendant cord and replace if needed.
Check to make sure correct program is selected for welding wire and shielding gas used.
Check wire feeder and welding power source settings.
B e
R e s e t
S e l e c t
B e
R e s e t
S e l e c t
Remedy
1
Program CRC Error
2
Program Range Error
If either error code appears, reset
the display to factory settings as fol-
lows:
Press Parameter Select push but-
ton or turn welding power source
Off and back On. Change settings
and continue.
Publicité
Table des Matières
