Table des Matières
Publicité
3-3. Overview And Controls
Example
To select Program 3, set to Non Adaptive, and set Arc Length to 36, proceed as follows:
Select top line by pressing
push button until > is on top
line, and turn knob until
Program 3 appears.
Press push button to select
second line, and turn knob so
Non Adaptive appears.
Select third line, and turn
knob to set arc length to 36.
OM-2805 Page 12
1
2
3
.
304 model power source shown.
> P r g
3
0 3 5 A l
A d a p t i v e
5 0
A r c
L e n g t h
P r g
3
0 3 5 A l
> N o n
A d a p t i v e
5 0
A r c
L e n g t h
P r g
3
0 3 5 A l
N o n
A d a p t i v e
>
3 6
A r c
L e n g t h
Overview
The control unit provides three
modes of operation:
CV Mig − control functions as a re-
mote voltage control.
Manual MIG Pulser − control func-
tions as a discrete pulsed MIG CC
control.
Synergic Pulser − programs that
use factory-entered values are
used to control process.
Setup screens (see Section 3-5) al-
low the type of welding power
source in use to be defined, pro-
grams or modes to be made inac-
cessible (locked out) to the opera-
tor, and the language used in the
displays (English, French, etc.) to
be defined.
Controls
1
Display
2
Parameter Select Push Button
Press button to move > on display.
The parameter indicated by > is
selected.
3
Parameter Adjust Knob
Turn knob to change selected pa-
rameter. Knob turns in either
direction.
When top line of display is selected,
turning knob accesses pre-written
pulse programs, Manual MIG Puls-
er mode, or CV MIG mode.
See example at left.
5 3 5 6
A r
5 3 5 6
A r
5 3 5 6
A r
ST-801 315-A
Publicité
Table des Matières
