Turn On The Scanner; Adjust Squelch - Albrecht AE75H Mode D'emploi

Turn on the Scanner

Turn on the scanner after it has been completely charged (Ni-MH
batteries) or alkaline batteries have been installed.
Note: Make sure the antenna is connected before you turn on the
scanner.
1. You can select the band plan (Band Plan 1 or 2) when you turn on
the scanner (default = Band Plan 2). Press and hold the
2-3 seconds to turn on the scanner and then press and hold 1 for
Band Plan 1 or 2 for Band Plan 2.The band plan will remain until
you change it again.
2. If this is the first time you have turned on the scanner, AllLocOut
displays. This means that no frequencies have been saved into
channels. Press Srch to begin searching.

Adjust Squelch

The scanner recognizes signals as transmissions if they exceed a signal
strength threshold. Adjusting the squelch sets this threshold level.
Increasing squelch requires a signal to be stronger to be seen as a
transmission. If you set the squelch too high, you will risk not receiving
transmissions that are lower than that threshold. Reducing the squelch
allows weaker signals to be accepted. However, if you lower the squelch
too much, you will hear white noise all the time.
1. Press Func and the press down and release the scroll control
knob. SqL and a number display.
2. Turn the knob until the interference is gone. Press the scroll
control knob again to set the level and return to the previous
function.
56 English
key for