Frequency Range - Albrecht AE75H Mode D'emploi

power the scanner using two AA rechargeable Ni-MH batteries or
optional alkaline batteries (not included).
Key Confirmation Tones- the scanner sounds a tone when you perform
an operation correctly, and an error tone if you make an error.
Battery Low Alert- warns you when battery power gets low. The Battery
Low icon flashes ( ) and a battery low tone sounds every 15
seconds until the scanner is recharged, turned off, or drained completely.
Battery Save- works when there is no transmission for 1 minute in Scan
Hold mode and in any Search Hold mode (does not work in Priority Scan
and Close Call modes).This feature turns off RF power for 1 second and
turns it on in 300ms intervals to extend the battery life.
Scan/Search Delay/Resume- controls whether the scanner pauses at
the end of the transmission to wait for a reply. You can set the Delay time
for each Channel, Close Call, Custom Search, and Service Search
mode.
Step Frequency- let you set your desired step frequency during Quick
Search, Custom Search, AIR Service Search, and Close Call.
Modulation Type- let you set your desired modulation type (AM or FM)
during Quick Search, Custom Search, CB Service Search, HAM Service
Search, Close Call, and each Channel.

Frequency Range

These tables list the frequency ranges, default frequency step, default
mode (AM or FM), and type of transmissions you can hear for each
range for Band Plan 1 or 2.
Select the band plan (Band Plan 1 or 2) when you turn on the scanner
(default = Band Plan 2). Press and hold the key for 2-3 seconds to
turn on the scanner while pressing and holding 1 for Band Plan 1 or 2 for
Band Plan 2. The band plan will remain until you change it again.
48 English