Delay - Albrecht AE75H Mode D'emploi

1. Manually select the channel you want for the Priority channel.
2. Press Func + Pgm, then press Func + Pri. P appears to the left of
the selected channel number.
3. Repeat Steps 1 and 2 for other channels for each bank you want
to program as a priority channel. From Scan Hold mode, press
Func + Pri to cycle through the Priority options.

Delay

Sometimes a user might pause before replying to a transmission. To
avoid missing a reply on a specific channel, you can program a 2-second
delay into channels or searches. The scanner continues to monitor the
channel frequency for an additional 2 seconds after the transmission
stops before resuming scanning or searching.
Mode
Scan
Search
Quick Search
and Close
Call
When the delay feature is on, DLY displays. If it is off, follow one of
these procedures to program a delay depending on how the scanner is
operating.
If the scanner is scanning and stops on an active channel where
you want to program a delay, quickly press Func + Dly before it
continues scanning again. DLY appears.
If the desired channel is not selected, manually select the channel,
then press Func + Dly. DLY appears.
If the scanner is searching, press Func + Dly. DLY appears and
the scanner automatically adds a 2-second delay to every
frequency it stops on in that band.
To turn off the 2-second delay, press Func+ Dly while the scanner is
monitoring a channel, scanning, or searching. DLY disappears.
Each channel can be set individually.
Custom Search: If one range is set, all ranges are set.
Service Search: Each band can be set as a unit.
Changes made to Delay assignment in one mode are
reflected in the other mode.
Delay Specification
English 71