Battery Replacement - GYS STARTPACK 12.24 Manuel D'utilisation

Translation of the original instructions

BATTERY REPLACEMENT

4
2
Product Battery
STARTPACK 12.24
G16EP
Regardless of how the STARTPACK 12.24 is being used (12V or 24V), always replace both batteries at
the same time.
To replace the batteries:
1
• The booster must be disconnected from the power supply.
• Then, the back panel must be unscrewed (9 screws) with a torx screwdriver (size 4) 1 and removed.
• Once the back panel has been removed, the batteries are visible, with one in front of the other (see picture). -
terminal on the left, + terminal on the right.
To remove the batteries, remove the screws (see picture 2 and 3 ) that enable the connection between the
•
battery and the STARTPACK at the + and - terminals.
- First remove the front battery.
- Then unscrew the fixing bar (striped area
- And remove the second battery.
Once the first battery is removed, make sure to insulate the terminals to prevent any short cir-
cuit. Then remove the second battery.
When putting new batteries, make sure to match the polarities of both batteries and STARTPACK
12.24. - Terminal on the left, + terminal on the right (see picture).
• Reposition and tighten the bottom battery, the fixing bar and the front battery in this order. Place the back panel
screws back on.
STARTPACK 12.24
1
Type Voltage (V)
Lead acid battery 2 x 12
) between the two batteries 4 .
Dimensions
Capacity (Ah)
(cm)
2 x 16 18 x 8 x 17
EN
4
3
Battery ref
53131
13