General Description - GYS STARTPACK 12.24 Manuel D'utilisation

Translation of the original instructions
The battery fitted in this device is recyclable. Please proceed accor-
ding to the applicable recycling regulations.
The battery must be removed from the device before the latter is dis-
carded.
The device must absolutely be disconnected from the power supply
network before removing the battery.

GENERAL DESCRIPTION

This stand-alone starter is aimed to start vehicles equipped with a 12V (6 elements) or 24V (12 elements) lead batteries
(liquid or gel electrolyte) from small cars to bigger trucks.
STARTPACK contains 2 high performance 12V batteries. For it to work properly and to ensure the durability of internal
batteries, it is necessary to connect the STARTPACK to the mains, and to turn the product on 12V position to be charged
after each use.
USING AS A STARTER
• Unplug the socket from the mains.
• Turn the battery-switch on OFF.
• Plug the red clamp to the (+) and the black clamp to the (-).
NB: In the event of polarity inversion, Startpack 12-24 will sound a buzzer and a show a red led
warning.
• Switch the selector on 12V or 24V depending on the battery of the vehicle you wish to start.
• Turn the key of your vehicle in order to activate the start function
NB : if the vehicle does not start, wait 3 minutes between attempts to start
A vehicle which does not start after the third attempt probably has a problem unrelated to the bat-
tery: alternator, spark plug,...
• Once the vehicle has started, turn the battery switch on OFF.
After a start or a high consumption of batteries, the red light will flash to warn you that internal
batteries should be recharged.
• Unplug the black clamp then the red clamp from the vehicle.
To preserve the life of internal batteries, be sure to recharge the product (see next paragraph) after
each use.
USAGE AS A CHARGER (RECHARGE OF INTERNAL BATTERIES)
In order to have your Startpack fully operational and to ensure maximum output power, it is advised to charge it after
each use, and leave it charging until its' next use.
Startpack includes a high quality automatic charger, which will recharge its 2 batteries to a 100% charge, monitoring is
not necessary and a maximum charge will be maintained due to the advanced charging cycle (Floating System).
• After every use, près utilisation, turn the battery switch on OFF and disconnect the clamps from
the vehicle.
• Connect the charger to a 230V 50/60Hz socket.
• Switch the button on 12V mode
10
- Orange light: charging – voltage increasing
STARTPACK 12.24
WARNING : If you do not plug the 12V socket, the charge process won't start
The product will show you the charge status :
EN