Lighting The Side Burner; Switching The Burners Off - Barbecook SIESTA 310 Mode D'emploi

MAN_GAS_SIESTA_310_310_CREME_DE_BBC_151001_B.book Page 10 Thursday, October 1, 2015 6:36 PM
Push in the control knob of one burner, set it to HIGH and
3
hold it for a moment. The build-in igniter will cause sparks,
which will light the burner.
Always light one main burner to start with. Never light all
1
main burners at the same time.
If the burner does not light after three attempts, set its
4
control knob to OFF, close the gas supply and wait 5
minutes. This allows any accumulated gas to escape.
Retry lighting the burner. If it still does not light, try lighting it
5
with a match or refer to "14 Troubleshooting" to determine
the cause of the problem.
9.2.2 U
SING A MATCH
Place a match in the match holder.
1
Open the lid and set the control knobs of the main burners to
2
OFF.
If no other burner is lit yet, open the gas supply and wait ten
3
seconds. This allows the gas to stabilize.
Light the match and hold it about 13 mm from the burner.
4
Set the control knob of one burner to HIGH.
5
Always light one main burner to start with. Never light all
1
main burners at the same time.
If the burner does not light within 5 seconds, set its control
6
knob to OFF, close the gas supply and wait 5 minutes. This
allows any accumulated gas to escape.
Retry lighting the burner. If it still does not light, refer to
7
"14 Troubleshooting" to determine the cause of the problem.
10

9.3 Lighting the side burner

The side burner can only carry vessels with a maximum
1
weight of 9 kg and a maximum diameter of 220 mm.
9.3.1 U
SING THE IGNITER
Open the lid and set the control knob of the side burner to
1
OFF.
If no other burner is lit yet, open the gas supply and wait ten
2
seconds. This allows the gas to stabilize.
Push in the control knob of the side burner, set it to HIGH
3
and hold it for a moment. The build-in igniter will cause
sparks, which will light the side burner.
If the burner does not light after three attempts, set its
4
control knob to OFF, close the gas supply and wait 5
minutes. This allows any accumulated gas to escape.
Retry lighting the side burner. If it still does not light, try
5
lighting it with a match or refer to "14 Troubleshooting" to
determine the cause of the problem.
9.3.2 U
SING A MATCH
Place a match in the match holder.
1
Open the lid and set the control knob of the side burner to
2
OFF.
If no other burner is lit yet, open the gas supply and wait ten
3
seconds. This allows the gas to stabilize.
Light the match and hold it about 13 mm from the side
4
burner.
Set the control knob of the side burner to HIGH.
5
If the side burner does not light within 5 seconds, set its
6
control knob to OFF, close the gas supply and wait 5
minutes. This allows any accumulated gas to escape.
Retry lighting the side burner. If it still does not light, refer to
7
"14 Troubleshooting" to determine the cause of the problem.

9.4 Switching the burners off

If you no longer use the burners, you have to switch them off.
Proceed as follows:
Close the gas supply.
1
Set the control knobs of the burners to OFF.
2
By closing the gas supply first, you make sure there is no
2
gas left in the appliance.
www.barbecook.com