Process Time; Stock Removal; Removal/Time; Force; Abrasive Dosing; Lubricant Dosing - Struers AbraPol-10 Mode D'emploi

Process Time; Stock Removal;
Removal/Time

Force

Abrasive dosing

Lubricant dosing

300 rpm on Sample Mover
and Disc
50
AbraPol-10
Instruction Manual
Depending on the mode selected either the process time; the stock
removal or a combination of both can be adjusted.
The maximum preparation time is 20 minutes in each phase.
The maximum stock removal is 1000 µm in each phase.
Pushing the knob allows you to adjust the force between 50 and
700 Newton.
Pushing the knob allows you to adjust the abrasive dosing level
between 0 and 20.
If a grinding or polishing disc with a surface containing abrasive is selected,
dosing is automatically set to OFF.
Pushing the knob allows you to adjust the lubricant dosing level
between 0 and 20. It is possible to toggle between ON and OF if
water is selected.
When using 300 rpm on the sample mover and 300 rpm on the
disc please note the following recommendations:
− Use disc cooling.
− Pre-dose sufficiently when working with new preparation
surfaces.
− Use a 200 mm sample holder on a 350 mm surface to
distribute the lubricant and abrasive adequately.
−
Use DP-Lubricant, Green or DP-Lubricant, Red.
DP-Lubricant, Blue is alcohol-based and will evaporate too
quickly.
IMPORTANT