Beta 1438SAC Mode D'emploi page 11

MOUNTING:
● Put the plate and the clutch mechanism on the flywheel;
● Centre the disk clutch using one of the suitable tool supplied
(fig. 8 - 9 - 10 - 11).
● Insert the three legs with the right threading but do not
tighten, otherwise you can damage the SAC system.
● Install the special clamp tool and lock it with the M8
locking knobs.
Please note that the bell is not connected to the flywheel.
● Rotate the special tool's handle to compress the cup spring
totally; Now the bell is close to the flywheel.
● Place and tighten the clutch's locking screws to the flywheel.
● Release the pressure of the tool, and remove all parts.
● Mount now the remaining three screws and finish the
operation.
7
Pressure plate
8
9
10
Plate
Flywheel
11
11