Tank Filling And Water Treatment - Skandika Fitness NEMO Mode D'emploi / Instructions De Montage

WATER TANK

Tank Filling and Water Treatment

Hand pump
1. Remove rubber fill plug from the top of the tank.
2. Place a large bucket of water next to the rower and position siphon with the rigid hose in the bucket
and the flexible hose into the tank as shown. Note: Make sure small air valve on the top of the si-
phon is closed before filling.
Note: Where water quality is known to be poor, we recommend the use of distilled water.
3. Begin filling tank by squeezing the hand pump of siphon. Use level gauge decal on side of tank to
measure volume of water in tank. Do not overfill tank. Note: In case the adjuster handle was not
set to „MAX" before filling, the volume in water tank may be indicated wrongly! This may
lead to water leakage!
4. After filling tank to the desired water level, open the valve on the top of the siphon to allow excess
water to escape.
5. Ensure that tank plug is replaced once filling and water treatment procedures are complete.
Hints on Siphon with handpumpe use: Putting the fill bucket higher than the tank will allow
the siphon to „self-pump" when adding water to the tank. Pay attention to the filling volume to
avoid a water leakage.
26
Tank Filling and Water Treatment Procedures
Note: 17 liters of water are required for maxi-
mum filling.
Tank plug
Caution
Fill tank with
adjuster
handle set
to "MAX"
only.