Progress PHP5320 Notice D'utilisation page 33

• If you have nonstick accessories, do not
clean them using an aggressive agents,
sharp edged objects or dishwasher. It
can destroy nonstick coating!
Cleaning the door gasket
• Regularly do a check of the door gasket.
The door gasket is around the frame of
the oven cavity. Do not use the appliance
if the door gasket is damaged. Contact
the Service Centre.
• To clean the door gasket refer to the
general information about the cleaning.
Pyrolytic cleaning
Warning! The appliance becomes very
hot. There is the risk of burns.
Important! Do not use Pyrolytic cleaning
function and the hob at the same time (if it
is installed with the appliance). It can cause
a damage to the appliance.
Before Pyrolytic cleaning:
1. Remove all removable parts and ex-
cess spillage from the appliance.
2. Remove the worst of the dirt manually.
3. Close the oven door correctly.
Using the Pyrolytic cleaning
1. Press
again and again until the dis-
play shows
– The display shows PYRO 1 or PYRO
2.
– In 3 seconds the display shows a
message to remove all removable
parts from the appliance.
2. While Duration
to set the duration for the Pyrolytic
cleaning:
– 2:00 for a low degree of dirt
– 2:30 for a high degree of dirt.
3. Press
to start the Pyrolytic cleaning.
The bars on the symbol come on one by
one to show that the temperature in the ap-
pliance increases.
When the appliance is at the preset temper-
ature, the door locks and the display shows
.
When the Pyrolytic cleaning is completed,
the display shows the time of day. The oven
door is locked. When the appliance cools
down, an acoustic signal sounds and the
door unlocks.
.
flashes, press
To stop the pyrolytic cleaning at any
time, press
End time for Pyrolytic cleaning
You can set the end time for Pyrolytic
cleaning with the clock function End
.
1. Do again step 1, 2 and 3 from
above procedure.
2. Press
3. The display shows an arrow
and the symbol
shows the time for the end of Pyro-
lytic cleaning.
4. Press
for the end of the Pyrolytic clean-
ing.
Shelf Support Rails
Removing the shelf support rails
1. Pull the front of the shelf support rail
away from the side wall.
2. Pull the rear shelf support rail away
or
from the side wall and remove it.
Installing the shelf support rails
Install the shelf support rails in opposite se-
quence.
progress 33
.
.
. The display
or to adjust the time