To Begin Pumping - Ameda Finesse Mode D'emploi

7.3 To Begin Pumping

Note:
Place pump base on a horizontal flat surface before use.
1.
INSERT TUBING
adapter into right
side of pump base,
then turn slightly
to the right while
pushing in firmly.
3.
TURN SUCTION
dial to right to turn on.
Turn up to your highest
comfortable suction
level. If discomfort, turn
suction down.
6.
Once milk flow
slows, try for another
TURN
let-down.
SPEED
all the way
up, then slow speed
when milk is flowing.
Repeat as needed.
16
a. b.
SINGLE
For
PUMPING:
Remove one
tube from the
tubing adapter
and close one
side.
4.
TURN SPEED
dial all the way to
the right to highest
speed to start milk
flow.
7.
TURN SUCTION
dial to left to turn
off.
2.
DOUBLE
For
PUMPING: Both
tubes should be
CENTER
attached to the
on breast to create
tubing adapter.
seal.
NOTE: Make sure upper
body is upright.
5.
8.
After pump is
off, if necessary,
INSERT
between breast(s)
and breast flange(s)
to break suction.
flange
Once milk flows,
TURN SPEED
dial to left to slow
pump speed to
help drain milk. Try
half way, adjust as
needed.
a finger