Assembly; Single And Dual Pumping; To Begin Pumping; Starting Pump - Ameda Ultra Mode D'emploi

Assembly

5

Single and Dual Pumping

The kit can be used to single or dual pump.
Insert the tubing adapter into the tubing adapter port of the pump.

To Begin Pumping

• Center nipple(s) in breast flange(s).
• Fill breast flange(s) with the breast(s) to create an air seal.

Starting Pump

• Choose power option, and connect pump to power source.
• Turn SUCTION dial to the right until light turns on. Pump is now on.
2
1. Insert diaphragm into upper chamber
1
of breast flange.
2. Snap adapter cap with tubing onto the top
of upper chamber.
3. Gently push white valve firmly onto ring on
3
underside of breast flange.
4. Screw bottle onto breast flange.
4
5. Push tubing adapter at end of tubing into tubing
adapter port on pump.
To single pump:
Remove one tube
and close tubing
adapter.
Turn dials to the right (clockwise) to
increase pump settings (faster SPEED,
stronger SUCTION). Turn dials to the left
(counter-clockwise) to decrease pump
settings (slower SPEED, gentler SUCTION).
To dual pump:
Both tubes should
be attached to
tubing adapter.
Dual pumping
with one hand
gives you a free
hand for other
things.
E N G L I S H
7