Warning; Toxic Gas Measurements (Figure 3-8) - MSA Orion Mode D'emploi

Détecteur multi-gaz
Masquer les pouces Voir aussi pour Orion:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operating Manual
If the Oxygen alarm condition is reached while using the
instrument as a personal or area monitor, leave the area
immediately; the ambient condition has reached a preset
alarm level. If using the instrument as an inspection device,
do not enter the area without proper protection. Failure
to follow this warning will cause exposure to a hazardous
environment which can result in serious personal injury
or death.

Toxic Gas Measurements (FIGURE 3-8)

• The Orion Multigas
Detector can be
equipped to detect:
• Carbon
Monoxide
(CO) and/or
• Hydrogen
Sulfide (H
S)
2
in the
atmosphere.
• When the alarm
setpoint is reached
for Carbon
Monoxide (CO)
and/or Hydrogen
Sulfide (H
S):
2
• Alarm Sounds
• Alarm Lights flash
• PPM CO or PPM H
If the Toxic Gas alarm condition is reached while using the
instrument as a personal or area monitor, leave the area
immediately; the ambient condition has reached a preset
alarm level. If using the instrument as an inspection device,
do not enter the area without proper protection. Failure to
follow this warning will cause over-exposure to toxic gases,
which can result in serious personal injury or death.
Chapter 3, Using the Orion Multigas Detector

" WARNING

Figure 3-8. Instrument in Toxic Gas Alarm
S label above the concentration flashes.
2
" WARNING
3-11

Publicité

Table des Matières
loading

Table des Matières