Inspection , Maintenance - OREC Snow Bull Manuel D'utilisation

1.4 Loading and unloading the machine
WARNING
・ Use the vehicle of appropriate size to transport the machine.
・ Park on a flat place for loading/unloading.
・ Secure the machine with a strong rope during transport.
Drive safely and avoid sudden starts and stops and sharp turning during transport.
・ Use a ramp designed for the job, be sure it is wide and sturdy enough and that the machine
stays in the middle of the ramp. Always use the lowest forward gear to load, and reverse to
unload.
1.5

Inspection , Maintenance

Periodic inspection is necessary for keeping the quality and performance of the machine. Please
perform an inspection before every operation, and ask your retailer for an annual inspection. Orec
America will bear no responsibilities for any accidents or problems caused by neglecting any
inspections.
WARNING
To avoid injury, accident, and damage of the machine, be sure to follow all instructions
bellow.
・ To keep the machine safe and in good condition, perform the daily and annual inspections, and
recommended maintenance.
・ When you inspect, adjust or maintain the machine, make sure all any parts have cooled down,
wear appropriate protective gear and use appropriate tools. Work on a flat and open area and
keep the machine balanced to prevent machine tipping.
・ Make sure all parts are at the correct position and are securely tightened after an inspection,
maintenance or replacing. When replacing the driving wheel, replace driving wheel mounting
bolt at the same time.
・ Do not modify this machine or add attachments witch are not OREC option.
・ Be sure to check that the covers of rotating parts are refitted correctly in their original positions
after being removed.
・ When rubber fuel lines become old, they can split and dangerous fuel leaks can occur. Change
rubber parts if they split or every 3 years regardless of damage. At this time, also change the
fastening bands for the new parts.
CAUTION
To avoid machine damage, keep these instructions.
・ When you wash the machine, do not get the engine wet.
・ Inspect and adjust the clutch, throttle and transmission carefully.
・ To avoid burns and fire, cover the machine only after making sure that the engine has cooled
down,
-5-