OREC Snow Bull Manuel D'utilisation page 18

＜ Tips＞
How to turn the machine
CAUTION
・ If anything , such as a rock, or branch, gets into the track, stop the machine immediately and
carefully remove the obstruction.
・ Please allow a "breaking-in" period after purchase for about 1 week, or 3-4 hours o operation,
by not overloading the plow.
・ Always start at the lowest speed (1), and increase as you are sure at the area you are clearing
is safe.
・ If you hit something, always stop the machine immediately and check for damages. Some
unrepaired damages can cause injuries.
・ Clean the machine after operation, to have it safe and ready for the next snow clearing project.
1. Push down the handle bar to keep the blade height, and lock it.
2. If you turn the machine around the front part of the track, you
can turn it comfortably.
・ If you experience difficulty pushing snow due to the
amount, or weight of the snow, adjust the height to
remove it.
・ If you feel the tracks slipping, you can increase
power of pushing by pushing down on the handle.
However, if the tracks continue to slip or the engine
loses power, this is due to an excessive weight of
snow. In this case, please clear snow more gradually
or adjust the height of the plow.
・ You can push the snow to one side by removing side
plate of plow. After removing side plate re-tighten the
nut firmly.
・ If the amount of snow is causing difficulty, you should
adjust the width (see diagram).
・ You can move the machine without starting the
engine by moving main clutch lever to the "START"
position.
-17-