OREC Snow Bull Manuel D'utilisation page 12

Handle, Handle adjusting bolt
Side Plate
Side plate fixing lever
The way to remove and attach the side plates
"Removing"
"Attaching"
Grasp
・ If you see snow or dusts on bolt slit, please remove them before
attaching the side plate.
The handle height is adjustable for the operator.
・ To adjust the handle height, stop the engine. Remove
the handle adjust bolt then re-tighten at the proper
position, making sure the grooves are aligned.
・ For storage only, the handle can be folded down.
CAUTION
・ Adjust the handle height holding it tight at the flat
area. If you don't tighten the adjusting bolt enough,
the handle will fold on its own.
・ When you fold in handle or adjust the handle height,
be sure not to pinch or bend the cable.
・ When you adjust the handle height, tighten the
adjusting bolt firmly aligning the groove at the bottom
of handle.
To avoid injury, accidents, or damage to the
machine, please follow all instructions.
... Grasp the side plate fixing lever, and rotate the
side plate to remove it.
... Align the bottom hole of the side plate with the bolt
slit. Then, grasp the side plate fixing lever to attach
the side plate.
-11-