Inspection And Maintenance - OREC Snow Bull Manuel D'utilisation

5.

Inspection and maintenance

Please inspect the machine using the "Periodic inspection table" ( Page 32) and "Inspection
before operation" (Page 30) section for safe and comfortable operation. Perform any maintenance
before working.
WARNING
・ Please inspect the machine in an open and flat area with the engine off.
・ Keep open flame away from the unit. Also be careful of static electricity and lightning during
operation.
・ Please do not start the engine in poor ventilation or indoors.
・ Engine and oil are at high temperatures immediately after engine stops. Make sure that any
parts cool down before any inspection, maintenance or lubrication.
Follow all instructions to avoid injury and damage.
5.1 Inspection and Changing oil
・ This machine is shipped WITHOUT engine oil. Fill with the recommended engine oil to the correct
level before starting the engine.
5.1.1 How to change the engine oil
・ If you use continuously under high-load or high temperature, change the oil before
recommended period of changing oil.
・ After changing oil, make sure to put the cover and oil filler cap securely.
First time： 5 hours
1.Place an oil pan under the transmission.
2.Remove the drain plug at the bottom of the engine
and drain old oil.
Note；
・ Removing the dipstick at the same time makes it easy
to drain the old oil.
3.After draining old oil, make sure to screw the drain
plug securely, and replace the dipstick
4.Add the recommended oil regarding "3.2 Inspection of
engine oil"( Page 13 ).
Period of changing oil
/ From the second time： Every 25 hours
-20-