Inspection Before Operation - OREC Snow Bull Manuel D'utilisation

3. Inspection before operation

To ensure safe operation always do the inspection according to "7.3 periodic inspection table "Page
32 and perform any necessary maintenance.
WARNING
・ Always stop the engine before inspection, adjustment, and maintenance.
・ Please check the position of levers, and the work area around you when you do the moving test
with engine on.
・ Please carefully read the warning labels on this machine.
Follow all instructions to avoid injury.
3.1 Inspection of fuel
WARNING
When you refuel the gas, please follow these instructions.
・ Please refuel the gas on a flat and well ventilated area.
・ Stop the engine.
・ Keep away from sources of ignition.
・ Do not refuel until the engine cools down
・ Be careful of static electricity. It could cause fire due to vaporized gas.
・ Do not overfill the fuel tank above the maximum level. If you spill gas, clean it in accordance
with local laws and regulations.
CAUTION
・ If you refuel the gas while it's snowing, make sure that the snow or rain doesn't get into the fuel
tank. It could cause engine failure.
・ Only use unleaded regular gasoline, as other types could damage the engine.
・ Gas deteriorates when left sitting and can cause damage to engines. Please change to fresh
gasoline if the machine has not been used over 30 days. Do not use gas that is kept in a plastic
container.
・ Remove the fuel filler cap after setting the unit in a
horizontal position, then check the amount of gas
from the fuel filler. "B" line is the maximum level. Do
not overfill the fuel tank.
Type of fuel： Regular unleaded gasoline
・ Make sure to close the fuel filler cap after refueling.
-12-