Burner Description; Burner Equipment; 1.2 Accessories - Riello Gulliver RG3 393T1 Manuel D'entretien

1.

BURNER DESCRIPTION

One stage light oil burner.

The burner meets protection level of IP X0D (IP 40), EN 60529.
 The burner is approved for intermittent operation as per Directive EN 267.
Fig. 1
1 – Oil pump
2 – Control-box
3 – Reset button with lock-out lamp
4 – Flange with insulating gasket
5 – Air damper adjustment assembly
1.1

BURNER EQUIPMENT

Flange with insulating gasket . . . . . . . No. 1
Screw and nuts for flange . . . . . . . . . . No. 1
Remote reset connection . . . . . . . . . . No. 1

1.2 ACCESSORIES

SOFTWARE DIAGNOSTIC KIT
A special kit is available that, by an optical link to a PC, shows the burner life together with operating hours, type
and number of failures, serial number, etc.
To visualise the diagnostics proceed as follows:
 Connect the kit supplied separately to the control box socket.
Reading of the information begins when the software programme included in the kit starts.
REMOTE RESET KIT
The burner has a remote reset kit (RS) consisting of a connection and a push-button operating at a dis-
tance of 20 metres max.
In order to install it remove the protective lock-out installed at the factory and insert the lock-out supplied
with the burner (see electrical diagram on page 6).
3280
8
4
9
D4681
Screws and nuts for flange to be fixed to boiler. . .No. 4
Flexible oil pipes with nipples . . . . . . . . . . . . . . . .No. 2
2
6
3
2
1
6 – Nozzle holder assembly
7 – Flame detector
8 – Flame tube
9 – Motor
GB
7 5