FAULT
Burner starts with an
ignition delay.
6.2 OPERATING IRREGULARITIES
FAULT
B u r n e r l o c k s o u t
during operation.
3280
POSSIBLE CAUSES
The ignition electrodes are wrongly
positioned.
Air output is too high.
Nozzle dirty or worn.
POSSIBLE CAUSES
Flame disappears 4 times.
Does not shut down.
Adjust them according to the
instructions of this manual.
Set the air output according to the
instructions of this manual.
Replace it.
Clean or replace flame detector.
Replace dirty or deteriorated nozzle.
Check efficiency of flame detector.
Check efficiency of pressure regulator's
piston.
Check efficiency of pump's on-off valve.
15 GB
SOLUTION
SOLUTION