Cleaning The Glass; Cleaning The Ash; External Cleaning; Seasonal Stoppages - Bronpi MURANO-E Mode D'emploi

9.2.

CLEANING THE GLASS

IMPORTANT:
Clean the glass only when it is cold in order to avoid possible explosion.
You can use specific products such as vitro ceramic-cleaning products. Do not use aggressive or abrasive products that stain the
glass.
You can find Bronpi vitro ceramic-cleaning product in the same Bronpi distributor where you bought your oven.
BREAKAGE OF GLASSES: the glasses, as they are vitro ceramic, resist until 750ºC and they are not subject to thermal shocks. The
breakage can only be caused by mechanical shocks (crashes or violent closing of the door, etc). Therefore, its replacement is not
included in the warranty.
9.3.

CLEANING THE ASH

All ovens have an ash pan for the ash collection.
We recommend emptying the ash pan regularly in order to avoid that it is full completely
so that the grille does not overheat. Moreover, we recommend leaving 2-3 cm of ash on
the base.
In the Murano-L model there is a separation, through a tray, between the wood furniture
and the area of the ash drawer.
It is advisable to carry out the cleaning of what is deposited in said tray regularly. In order
to do this, lift the piece through the front of the woodshed and let it fall inside it as shown in
drawing D17 and vacuum the deposited ash and, then, return it to its position.
9.4.

EXTERNAL CLEANING

Do not clean the external surface of the oven with water or abrasive products because they may damage the fireplace. Use
a feather duster or a rag a bit wet.

10. SEASONAL STOPPAGES

After cleaning the chimney and the oven by removing the ash and other residues, close all doors and regulators.
It is recommended to clean the chimney at least once a year. Meanwhile, check the joints because if they are not in good condition (they do
not adjust to the door), they do not guarantee the proper operation of the oven! For this reason, it would be necessary to change them. You
can find this spare part in the same Bronpi distributor where you bought your oven.
If there is humidity in the place where the oven is installed, put absorbent salts inside the equipment. Protect the internal parts with neutral
vaseline in order to keep the appearance along the time.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS 21
D17
OVENS