Safety Measures; Intervention In Case Of Emergency; Oven Coating And Installation - Bronpi MURANO-E Mode D'emploi

• Make sure that there is proper ventilation in the place where it is installed (air intake) (see section 5 of the manual).
• Avoid the installation in places where there are collective ventilation pipes, hoods with or without extractor, B type gas equipments,
heat pumps or equipments that can cause that the draw is not good if they are used at the same time.
• Make sure that the smoke duct and the pipes used for the chimney are suitable for the operation of the oven.
We recommend that you call your fitter in order to check both the chimney as well as the air flow for the combustion.
This product can be installed near the walls as long as they comply with the following requirements:
The fitter must assure that the wall is completely made of brick masonry, thermo-clay block, concrete, bricks, etc, and that it is coated by
materials that can support high temperature.
Therefore, for any other type of material (drywall, wood, non-ceramic glass, etc), the fitter must provide sufficient insulation or keep a
minimum safety distance to the wall of 80-100 cm.
Keep any flammable or heat sensitive materials (furniture, curtains, and clothing) at a minimum distance of about 100cm, including the area in
front of the loading door. Measurements below the minimum distances should not be used.
3.1.

SAFETY MEASURES

During the installation of the equipment, there are risks to be taken into account, so you should follow the next safety measures:
a. Do not place flammable objects above.
b. Do not place the oven near combustible walls.
c. The oven should only be used when the ash pan is inserted.
d. It is recommended to install carbon monoxide detector (CO) in the room where the equipment is installed.
e. Use the gloves included for opening and closing the door as well as manipulating the controls as these can be very hot.
f. Solid combustion residues (ashes) should be collected in an airtight container and resistant to fire.
g. The appliance should never be turned on in the presence of emission of gases or vapours (e.g., linoleum glue, gasoline, etc).
h. Do not place nearby flammable materials.
WARNING!!
It is noted that both the oven and the glass get very hot and should not be touched.
3.2.

INTERVENTION IN CASE OF EMERGENCY

If there is fire in the chimney:
a. Close the loading door.
b. Close primary and secondary air intakes.
c. Put the fire out by using carbon dioxide extinguishers (CO2 powder).
d. Request for the immediate intervention of the fire-fighters.
DO NOT PUT OUT THE FIRE WITH WATER.
WARNING:
The manufacturer declines any responsibility for the malfunction of an installation not subject to the requirements of these
instructions or the use of additional products not appropriate.
3.3

OVEN COATING AND INSTALLATION

When the Murano-E model is installed in a pre-existing chimney or a coating is made, it is essential that the space between the upper part,
the sides of the appliance and the non-combustible material of the hood (which seals the base of the chimney) is constantly ventilated. For
this reason, it is necessary to allow fresh air to enter from the bottom of the coating and an outlet at the top (hot air outlet) through the hood. In
doing so, we will improve the functioning of the set because we are establishing a natural convection circuit. Each of these openings must be
free and not sealed, with a minimum surface area of at least 3 dm2 (for example a grille of 30x10cm).
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS 16 OVENS