Programming Sequence - Erreka DOLFIN Manuel De L'utilisateur

START UP AND PROGRAMMING
3

PROGRAMMING SEQUENCE

Display
off ENTER
á
or
indicating
à
CL

Before entering the programming menus, it is
necessary to close the gate or disconnect the device
and then reconnect.

Press the ENTER button to access the programming
menus.
The display shows "C"1 01 or "C"1 0 2.

Use the keys ^ and
and confirm by pressing ENTER.

Use ESC to go back to the previous display.

To leave the programming menu, press ESC several
times until the display goes off or shows CL.
Initial Conditions Programming (D1= "C")
1 Press ENTER to access the programming menus. The
display lights up and D1 flashes.
2 Press the buttons ^ and
C flashing. Press ENTER to confirm. D2 flashes.
D1 D2 Parameter
C 1 Motor turning direction
4
Opening safety device (photocell
or strip)
5
Closing safety device (photocell
or strip)
60
Installation Manual
General navigation through the programming parameters and menus
D1
C
ESC
Select the value
using ^ and
V
to select the required values,
V
until D1 shows the letter
V
D3
0
0
0
1
1
0
1
1
D2
ENTER
á
1
ESC
à
Select the value
using ^ and
V
1 Programme the prior conditions (see "Initial
Conditions Programming (D1= "C")" on page 60).
2 Record the pedestrian and total opening radio
codes, along with the gate open/close (see "Radio
code programming (only with RSD) and gate open/
close programming (D1= "P")" on page 61).
3 Programme the functioning mode, automatic
standby time and pedestrian opening (see "Main
Functions Programming (D1= "F")" on page 61).
4 Programme the advanced functions (see "Advanced
Functions Programming (D1= "A")" on page 62).
3 Press the buttons ^ and
parameter appears. Press ENTER to confirm. D3 and
D4 flash.
4 Press the buttons ^ and
D4 value appears (see chart). Press ENTER to
confirm.
5 Press ESC to return to the previous display.
Option
D4
default
1 x
2
0 x
0
1
0
x
0
1
D3 - D4
ENTER
á
0 X
ENTER
(confirming)
à
Select the value using
^ and
ESC
(unconfirmed)
à
until the required D2
V
until the required D3 and
V
Options
Device not installed
Device without testing
Device with testing
Device not installed
Device without testing
Device with testing
V