Erreka DOLFIN Manuel De L'utilisateur page 62

INSTALLATION
Connection of safety transmitter-receiver photocells in closing (SG.C, FT1)
Connection of safety transmitter-receiver photocells in opening (SG.A, FT2)
Connection to the grid
T
58
Installation Manual

1 Complete the connections as shown in the figure.
2 Duly programme the operator:
FT1


1 Complete the connections as shown in the figure.
2 Duly programme the operator:
FT2

1 Connect the line cable (L) to the connection strip
2 Connect the earth cable (T) to the operator frame.
3 Ensure the main fuse (F) is correctly in place.

P153H
We recommend installing opening and closing
safety photocells.

Closing photocells with pre-testing: C511

Closing photocells without pre-testing: C510

Without closing photocells: C500
For further details on programming, see "Start up
and programming" on page 59.
We recommend installing opening and closing
safety photocells.

Opening photocells with pre-testing: C411

Opening photocells without pre-testing: C410

Without opening photocells: C400
For further details on programming, see "Start up
and programming" on page 59.
lower cable connector and the neutral cable (N) to
the upper cable connector.

DOS424E (230Vac/50Hz): FUS 5x20, 2.5A

DOS424EM (125Vac/60Hz): FUS 5x20, 4A
Never forget to connect the earth cable, in
order to prevent the risk of electrical discharge.