Installation; Tools And Materials; Initial Conditions And Checks; Environmental Conditions - Erreka DOLFIN Manuel De L'utilisateur

INSTALLATION

1

TOOLS AND MATERIALS

Set of screwdrivers
Fixed wrenches
Marker pencil
Tape measure
Electrician's scissors
2

INITIAL CONDITIONS AND CHECKS

Initial conditions of the gate

Check that the size of the gate is within the
admissible range of the operator (see the
technical features of the operator).

If the gate to be automated has a personnel
door, use a safety device to prevent the
operator from running with the personnel door
open.

The gate must have an opening and a closing
stopper.

Environmental conditions


This device is not suitable for installation in
inflammable or explosive environments.
Electrical power supply installation

Ensure the power supply installation fulfils the
following requirements:
• The nominal voltage of the installation must
coincide with that of the control board.
• The installation must be able to support the
power consumed by all the automatic key
devices.
• The installation must be earthed.
Saw for cutting metal
Electrical drill and broaches
Underground electrical cable ducts

The gate must be easy to handle manually, namely:
• It must be balanced, in order to ensure the effort
made by the motor is minimum.
• There should be no stiffness throughout its open/
close.

Do not install the operator in a gate which does
not work correctly in manual operation, as this
may lead to accidents. Repair the gate before
installing.

Check that the admissible environmental
temperature range for the operator is suitable
for the location.
• The electrical installation must comply with
low voltage regulations.
• The installation elements must be properly
secured and in a good state of conservation.
 If the electrical installation does not comply
with the foregoing requirements, repair before
installing the automatic key device.
DOLFIN operator for sliding gates
English
53