Technical Data; Specified Conditions Of Use - Güde TK 2100 Traduction Du Mode D'emploi D'origine

ENGLISH
24

Technical Data

Circular table saw ...................................................................................................................................GTK 2100
Art. No .................................................................................................................................................................................................... 55168
Service connection ...................................................................................................................................................230 V/ 50 Hz
Rated input ...........................................................................................................................................................1200W S6 40%
Idle speed ........................................................................................................................................................................4500 min
Saw blade dia. x hole dia ...................................................................................................................................... 210 x 30 mm, HM 24 Z
Cutting depth max. 90° ......................................................................................................................................................62 mm
Cutting depth max. 45° ......................................................................................................................................................43 mm
Weight ..................................................................................................................................................................................... 14,5 kg
Dimensions LxWxH (in mm) ...................................................................................................................525 x 470 x 440 mm
Noise and Vibration Information
Guaranteed sound power level L
Wear ear protectors!
1) Measured according to EN ISO 11202:1995/AC:1997, under load, Uncertainty K=3 dB (A)
2) The values stated are emission values and as such do not necessarily constitute values which are safe for the
workplace. Al- though there is a correlation between emission levels and environmental impact levels, whether
further precautions are neces- sary cannot be derived from this. Factors influencing the actually present envi-
ronmental impact level in the workplace include the characteristics of the work area and other noise sources, i.e.
the number of machines and other neighbouring work process- es. The permitted workplace values can likewise
vary from country to country. This information is intended to assist the user in estimating hazards and risks.
The appliance meets EN 61000-3-11 requirements and is subject to special connection conditions. That means
that use on optionally selected connection points is inadmissible. The appliance can lead to occasional voltage
fluctuations under unfavourable power conditions. The appliance is only designated to be used for connection
points not exceeding the maximum allowed impedance of Zmax = 0,233 Ω. As a user, you must make sure your
connection point on which you want to use the appliance meets the above-mentioned requirements – after
agreement with your electricity supplier if necessary.
Read and understand the operating instructions
before using the appliance. Abide by all the safety
measures stated in the service manual. Act responsib-
ly toward third parties.
In case of any doubts about connection and operati-
on refer please to our customer center

Specified Conditions Of Use

The circular saw is only intended to cut wood and
wood like products.
Do not use this product in any other way as stated for
normal use.
Not observing general regulations in force and
instructions from this manual does not make the
manufacturer liable for damages.
2)
...................................................................................................................................... 105,4 (A)
WA
Requirements for operating staff
The operating staff must carefully read the Opera-
ting Instructions before using the appliance.
Because wrong using of the appliance can be risky,
only competent persons are allowed to operated it.
Operator must be trained properly concerning adjust-
ment, operation and appliance using.
Qualification: : Apart from the detailed instructions
by a professional, no special qualification is necessary
for appliance using.
Minimum age: : The product has been designed
to be used by persons over 16 years of age: If the
product is to be used by children below the age of 8
or persons with reduced physical, sensory or mental
skills or with a lack of experience and knowledge,
they must be supervised or instructed in the safe use
of the appliance and understand the resulting risks.
GTK 2100
-1