Connecting To The Time Distribution Network; Parallel Distribution With Inverted Polarity; Default Configuration - Bodet Style 5S Hôpital Notice D'installation

III

– Connecting to the time distribution network

Connect the 100-240VAC 50/60Hz mains power supply. (See page 7)

3.1 Parallel distribution with inverted polarity

Minute // (12-24-48 Volt), ½ minute // (24 Volt) and AFNOR
1) Ensure that the clock is designed to be synchronised by "Impulse" or to be connected to a time
code distribution network that meets the AFNOR standard .
2) Connect the impulse cable to terminal strip (A). Use the correct polarity for impulse synchronisation.
There is no polarity in AFNOR.
Minute or ½ minute mode (only)
3) Select the impulse frequency (minute or ½ minute) (refer to page 14) and display mode
(refer to page 11).
4) Set the clock to the correct time (refer to page 10).
IV

– Default configuration

Restore factory settings by keeping the red button on the electronic board pressed until the clock
turns black.
Location of button on the electronic board (example shows an Impulse card):
AFNOR
OR
IMPULSE
EN
A
A
9