Setting In Operation - Installation; Clock With Batteries; Fitting The Batteries; Receiver Clock With External Power Supply - Bodet Cristalys 14 Instructions De Mise En Service Et D'utilisation

III - SETTING IN OPERATION - INSTALLATION

3.1 Clock with batteries

Fitting the batteries

a. Turn the clock over onto a table.
Unscrew the anti-theft locking screw.
Push in front of the 2 arrows on the wall bracket to
unclip it.
Remove the wall bracket / battery cover on the
back of the clock.
b. Insert the 4 batteries (type LR14) matching up the [+]
and [-] symbols.

3.2 Receiver clock with external power supply

For Cristalys receiver clock with the option external
power supply : connect the low voltage power
supply, 6V to 24 V AC or DC on terminals 3 and 4.
The external power pack must be SELV-type,
supplying voltage contained between 6 and 24V AC/
DC, 10 mA minimum and in accordance with the limited
power supply criteria of the EN60950 standard § 2.5.
Do not insert batteries if an external power supply is connected.

3.3 Link-up to a time distribution network

Cristalys clocks can be synchronised by Minute or ½ minute //, or IRIG-B/AFNOR time
All manuals and user guides at all-guides.com
252
Reset
SELECT
∞
C
Anti-theft locking
screw
Fig.: 3
LR 14
LR 14
LR 14 LR 14
Power supply 6V to 24
V AC or DC, minimum
10 mA without polarity
distinction
Diag.: 2
23